Hello. Sign In
Standards Store
GM C200 2nd Edition, May 1, 2011
Complete Document
Not Active, See comments below
Penetration Gages and Gaging for Type 1A Cross Recesses
Includes all amendments and changes through IN4D, May 2011
Additional Comments: ENGLISH * INACTIVE FOR NEW DESIGN
Page Count:3
PDF :
$33.00 USD
In Stock
Print  :
$33.00 USD
In Stock
Print + PDF :
$52.80 USD
You save 20%
In Stock
GENERAL. Penetration gaging provides a means for determining the suitability of the Type 1A cross recesses formed in the heads of screws and may be used to indicate deficiencies in the dimensions of recesses specified in the dimensional tables for the respective screws. Penetrations which are too deep indicate the possibility of a thin section between the head and shank of screw, a weakness which might result in twisting-off screw heads during tightening of the screws. Use of screws having shallow penetrations might also results in production problems such as reaming of recesses or excessive wear on driver bits.