Hello. Sign In
Standards Store

GMW17196

2nd Edition, May 1, 2015

Complete Document

Step Mu Evaluation



View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

EN
Additional Comments:
ENGLISH CURRENT VERSION
Format
Details
Price (USD)
PDF
Single User
$33.00
Print
In Stock
$33.00
PDF + Print
In Stock
$52.80 You save 20%
Add to Cart

People Also Bought These:

ISO 16845-2
ISO 11898-1
ISO 11898-2
ISO 11898-5

Product Details:

  • Revision: 2nd Edition, May 1, 2015
  • Published Date: May 2015
  • Status: Active, Most Current
  • Document Language: English
  • Published By: General Motors Worldwide (GMW)
  • Page Count: 13
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

Introduction

Note: Nothing in this standard supercedes applicable laws and regulations.

Note: In the event of conflict between the English and domestic language, the English language shall take precedence.

Purpose. Provide a common global development and validation performance evaluation of a driveline system that utilizes traction enhancing driveline hardware, e.g., Active On Demand (AOD) All Wheel Drive (AWD). This procedure is also performed to evaluate the performance of driveline components after being subjected to severe loads resulting from multiple vehicle launches on ʺstep muʺ surfaces, i.e., surfaces that change from small frictional coefficient (μ), i.e., ʺlow muʺ, to large frictional coefficient, i.e., ʺhi muʺ.

Applicability. Passenger cars and light trucks equipped with an AOD AWD system. Typically these systems have a clutch mechanism that splits torque between front and rear axle as required.

Remarks. This test is typically run by the GM Vehicle Dynamics group or the GM Driveline group and is used for development/validation of the drivetrain or traction performance. These systems may include but, are not limited to, AOD AWD and regular AWD systems, drive shafts, half shafts, axles, torque couplings, and driveline disconnects.