Hello. Sign In
Standards Store
Look Inside

IEC 60071-2

3rd Edition, December 1, 1996

Complete Document

Insulation co-ordination - Part 2: Application guide



Detail Summary

Active, Most Current

EN
FR
Additional Comments:
BILINGUAL * SAME AS BS 5622 P2
Format
Details
Price (USD)
PDF
Single User
$387.00
Print
In Stock
$387.00
Add to Cart

People Also Bought These:

IEEE C2 (NESC)
ASTM E1527
ASTM E2018
AWS D10.12M/D10.12

Product Details:

  • Revision: 3rd Edition, December 1, 1996
  • Published Date: December 1996
  • Status: Active, Most Current
  • Document Language: English, French
  • Published By: International Electrotechnical Commission (IEC)
  • Page Count: 260
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This part of IEC 71 constitutes an application guide and deals with the selection of insulation levels of equipment or installations for three-phase electrical systems. Its aim is to give guidance for the determination of the rated withstand voltages for ranges I and II of IEC 71-1 and to justify the association of these rated values with the standardized highest voltages for equipment.

This association is for insulation co-ordination purposes only. The requirements for human safety are not covered by this application guide.

It covers three-phase systems with nominal voltages above 1 kV. The values derived or proposed herein are generally applicable only to such systems. However, the concepts presented are also valid for two-phase or single-phase systems.

It covers phase-to-earth, phase-to-phase and longitudinal insulation.

This application guide is not intended to deal with routine tests. These are to be specified by the relevant product committees.

The content of this guide strictly follows the flow chart of the insulation co-ordination process presented in figure 1 of IEC 71-1. Clauses 2 to 5 correspond to the squares in this flow chart and give detailed information on the concepts governing the insulation co-ordination process which leads to the establishment of the required withstand levels.

The guide emphasizes the necessity of considering, at the very beginning, all origins, all classes and all types of voltage stresses in service irrespective of the range of highest voltage for equipment. Only at the end of the process, when the selection of the standard withstand voltages takes place, does the principle of covering a particular service voltage stress by a standard withstand voltage apply. Also, at this final step, the guide refers to the correlation made in IEC 71-1 between the standard insulation levels and the highest voltage for equipment.

The annexes contain examples and detailed information which explain or support the concepts described in the main text, and the basic analytical techniques used.