Connectors for Electronic Equipment - Part 4-101: Printed Board Connectors
with Assessed Quality - Detail Specification for Two-Part Connector
Modules, Having a Basic Grid of 2,0mm for Printed Boards and Backplanes in
Accordance with IEC 60917
Includes all amendments and changes through Corrigendum , November 2003
1) The IEC (International Electrotechnical Commission) is a
worldwide organization for standardization comprising all national
electrotechnical committees (IEC National Committees). The object
of the IEC is to promote international co-operation on all
questions concerning standardization in the electrical and
electronic fields. To this end and in addition to other activities,
the IEC publishes International Standards. Their preparation is
entrusted to technical committees; any IEC National Committee
interested in the subject dealt with may participate in this
preparatory work. International, governmental and non-governmental
organizations liaising with the IEC also participate in this
preparation. The IEC collaborates closely with the International
Organization for Standardization (ISO) in accordance with
conditions determined by agreement between the two
2) The formal decisions or agreements of the IEC on technical
matters express, as nearly as possible, an international consensus
of opinion on the relevant subjects since each technical committee
has representation from all interested National Committees.
3) The documents produced have the form of recommendations for
international use and are published in the form of standards,
technical specifications, technical reports or guides and they are
accepted by the National Committees in that sense.
4) In order to promote international unification, IEC National
Committees undertake to apply IEC International Standards
transparently to the maximum extent possible in their national and
regional standards. Any divergence between the IEC Standard and the
corresponding national or regional standard shall be clearly
indicated in the latter.
5) The IEC provides no marking procedure to indicate its
approval and cannot be rendered responsible for any equipment
declared to be in conformity with one of its standards.
6) Attention is drawn to the possibility that some of the
elements of this International Standard may be the subject of
patent rights. The IEC shall not be held responsible for
identifying any or all such patent rights.
International Standard IEC 61 076-4-101 has been prepared by
subcommittee 48B: Connectors, of IEC technical committee 48:
Electromechanical components and mechanical structures for
This part 4-101 constitutes the detail specification in the IEC
quality assessment system for electronic components (IECQ) for
two-part connector modules having a basic grid of 2,O mm for
printed boards and backplanes in accordance with IEC 60917.
The QC number that appears on the front cover of this
publication is the specification number in the IEC Quality
Assessment System for Electronic Components (IECQ).
This publication has been drafted in accordance with the ISO/IEC
Directives, Part 3.
The committee has decided that the contents of this publication
will remain unchanged until 2005. At this date, the publication
• replaced by a revised edition, or
Order online or call: Americas: +1 800 854 7179 | Asia Pacific: +852 2368 5733 | Europe, Middle East, Africa: +44 1344 328039