ISO 104 4th Edition, September 15, 2015
Rolling bearings - Thrust bearings - Boundary dimensions, general plan
Additional Comments: ENGLISH
Published By:International Organization for Standardization (ISO)
This International Standard specifies preferred boundary dimensions for single-direction and doubledirection thrust bearings with flat back faces.
In addition, it gives the minimum bore diameters of housing washers and maximum outside diameters of shaft washers of bearings in dimension series 11, 12, 13, 14, 22, 23 and 24.
Guidelines for the extension of this International Standard for single-direction thrust bearings are given in Annex A.
NOTE Boundary dimensions for aligning thrust bearings (none flat back faces) and aligning seat washers are given in ISO 20516.