Hello. Sign In
Standards Store

ISO DIS 5167-5

2015 Edition, January 29, 2015

Complete Document

MEASUREMENT OF FLUID FLOW BY MEANS OF PRESSURE DIFFERENTIAL DEVICES INSERTED IN CIRCULAR CROSS-SECTION CONDUITS RUNNING FULL - PART 5: CONE METERS



View Abstract
Product Details
Document History

Detail Summary

Superseded By: ISO 5167-5

Additional Comments:
NOW A PUBLISHED STD * SEE ISO 5167-5
Format
Details
Price (USD)
Print
In Stock
Call for Quote
Add to Cart

Product Details:


Description / Abstract:

This part of ISO 5167 specifies the geometry and method of use (installation and operating conditions) of cone meters when they are inserted in a conduit running full to determine the flow rate of the fluid flowing in the conduit.

As the uncertainty of an uncalibrated cone meter may be too large for a particular application, it may be deemed essential to calibrate the flow meter in accordance with section 7 of this document. Calibrated meters shall only be used over the calibrated Reynolds number range.

This part of ISO 5167 also provides background information for calculating the flow rate and is applicable in conjunction with the requirements given in ISO 5167-1.

This part of ISO 5167 is applicable only to cone meters in which the flow remains subsonic throughout the measuring section and where the fluid can be considered as single-phase. Uncalibrated cone meters can only be used within specified limits of pipe size, roughness, ╬▓ and Reynolds number. This part of ISO 5167 is not applicable to the measurement of pulsating flow. It does not cover the use of uncalibrated cone meters in pipes sized less than 50 mm or more than 500 mm, or where the pipe Reynolds numbers are below 8 x 104.

A cone meter is a primary device which consists of a cone-shaped restriction held concentrically in the centre of the pipe with the cone apex upstream. The design of cone meter defined in this standard has one or more upstream pressure tappings in the wall, and a downstream pressure tapping positioned in the back face of the cone with the connection to a differential pressure transmitter being a hole through the cone to the support bar, and then up through the support bar.

Alternative designs of cone meters are available; however, at the time of writing there is insufficient data to fully characterise these devices, and therefore these meters shall be calibrated in accordance with Section 7.
The 9000 Store