Hello. Sign In
Standards Store
MIL-C-63128 1977 Edition, February 15, 1977
Complete Document
Active, Most Current
CARTRIDGES: 40MM, GROUND SMOKE MARKERS, M713, M715 AND M716; BODY PART FOR
Includes all amendments and changes through Validation Notice 3, October 11, 2013
Additional Comments: INACTIVE FOR NEW DESIGN
PDF :
$32.00 USD
In Stock
Print  :
$35.00 USD
In Stock
Print + PDF :
$46.90 USD
You save 30%
In Stock
1.1 This specification contains requirements not normally covered by the drawings and provides quality assurance provisions for the fabrication of one type of Body for Cartridges: 40MM, Ground Smoke Markers, M713, M715 and M716.

-The following documents of the issue in effect on date of invitation for bids or request for proposal, form a part of this specification to the extent specified herein.
     SPECIFICATIONS

        MILITARY

           MIL-C-5541   - Chemical Films and Chemical Film
                          Materials for Aluminum and Aluminum Alloys
           MIL-A-48078  - Ammunition, Standard Quality Assurance
                          Provisions, General Specification For

     STANDARDS

        MILITARY

           MIL-STD-105  - Sampling Procedures and Tables for
                          Inspection by Attributes
           MIL-STD-1169 - Packaging, Packing and Marking for
                          Shipment of Inert Ammunition Components

     DRAWINGS


Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Commander, Picatinny Arsenal, Dover, New Jersey 07801 by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.
        PICATINNY ARSENAL

           9258731 - Body




-The following documents form a part of this specification to the extent specified herein. Unless otherwise indicated, the issue in effect on the date of invitation for bids or request for proposal shall apply.
     AMERICAN SOCIETY FOR TESTING AND MATERIALS

        ASTM B 117-73 - Standard Method of Salt
                        Spray (Fog) Testing




(Application for copies should be addressed to: American Society for Testing and Materials, 1916 Race Street, Philadelphia, Pa. 19103).