Hello. Sign In
Standards Store
MIL-C-80036 Revision C, December 19, 1985
Complete Document
Not Active, See comments below
CUTTING MACHINE, OXYGEN FLAME AND PLASMA ARC, AUTOMATIC, STATIONARY, PHOTOELECTRIC TRACER CONTROLLED
Includes all amendments and changes through Cancellation Notice 1, October 27, 1998
Additional Comments: CNCL NO S/S
PDF :
$32.00 USD
In Stock
Print  :
$36.00 USD
In Stock
Print + PDF :
$47.60 USD
You save 30%
In Stock
This specification covers stationary, automatic, flame and plasma arc cutting machines for cutting various shapes from steel plate or other materials. The machines are controlled by a photoelectric tracer capable of tracing line drawings. The plasma arc system used with the cutting machines is covered by MIL-C-80090.

This specification covers cutting machines of the following types and sizes. The type and size to be furnished, shall be as specified (see 6.2.1).
    Type I  - For cutting with an oxygen-fuel gas torch having
              straight line and contour cutting speeds with a
              range of not greater than 2 inches per minute
              (IPM) to not less than 40 IPM.

    Type II - For cutting with a plasma arc torch or oxygen-fuel
              gas torch having straight line cutting
              speed with a range of not greater than 50 IPM
              to not less than 240 IPM and contour cutting
              speed of not greater than 2 IPM to not less than
              120 IPM.

    Size 1 -  48 in. width ×  96 in. length cutting capacity.
    Size 2 -  60 in. width × 120 in. length cutting capacity.
    Size 3 -  72 in. width × 144 in. length cutting capacity.
    Size 4 -  96 in. width × 192 in. length cutting capacity.
    Size 5 - 120 in. width × 240 in. length cutting capacity.
    Size 6 - 144 in. width × 288 in. length cutting capacity.


Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Defense Industrial Plant Equipment Center, ATTN: DIPEC-SSG, Memphis, Tennessee 38114-5297 by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.