Hello. Sign In
Standards Store
MIL-DTL-11484/209 Revision A, September 27, 1996
Complete Document
Not Active, See comments below
LAPEL BUTTON, MERITORIOUS CIVILIAN SERVICE AWARD, DEFENSE INVESTIGATIVE SERVICE
Includes all amendments and changes through Cancellation Notice 3, January 27, 2010
Additional Comments: CNCL NO S/S
PDF :
$27.00 USD
In Stock
Print  :
$30.00 USD
In Stock
Print + PDF :
$39.90 USD
You save 30%
In Stock
This specification is approved for use by all Departments and Agencies of the Department of Defense.

The requirements for acquiring the product described herein shall consist of this specification sheet and the issue of MIL-DTL-11484 listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation. FIGURE
MATERIAL:  Red Brass

FINISH:  Nickel Plated, Silver Plated, Oxidized, Relieved, Matte Finish
           and shall match TIOH Metal Finish Chip Number 14.

DIMENSIONS:
    DIAMETER:  ¾ inch (1.91 cm) (REF)
    THICKNESS (At Thickest Point):  0.080 inch ± 0.005 inch (0.203 cm ±
             0.012 cm)




NOTES:

1. The term (REF) refers to the measurements taken from the Government furnished hub or die.

2. The attaching device shall be prong with pick and wing type clutch. The prong shall be centered on the reverse side and fused or soldered to the label button.

CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes.