Hello. Sign In
Standards Store
MIL-G-53082 1989 Edition, August 14, 1989
Complete Document
Not Active, See comments below
GENERATOR SETS, DIESEL ENGINE DRIVEN 3KW, 60 HERTZ, 400 HERTZ, AND 28 VOLT DIRECT CURRENT
Includes all amendments and changes through Cancellation Notice 2, December 21, 1998
Additional Comments: CNCL NO S/S
PDF :
$38.00 USD
In Stock
Print  :
$42.00 USD
In Stock
Print + PDF :
$56.00 USD
You save 30%
In Stock
This specification covers the military design, tactical utility, air-cooled, diesel engine driven (DED) generator sets (herein after referred to as sets or set), 3 kilowatts (kW), 60 hertz (Hz) and 400Hz and 28 volt direct current (Vdc) and an optional acoustic suppression kit.

The set shall be type I (tactical), class 2 (utility), size 3 (3kW) and of the following modes as specified (see 6.2):
           Mode II - 400Hz
           Mode III - 60Hz
           Mode IV - 28 Vdc




Mode IV generator sets shall be rated 28 Vdc. The mode II and mode III generator sets shall be rated 0.8 power factor (pf) lagging and shall be reconnectable for the following voltage ratings:

a. 1 phase, 2 wire, 120 volts.

b. 1 phase, 3 wire, 120/240 volts.

c. 3 phase, 3 wire, 120 volts line-to-line.

d. 3 phase, 4 wire, 120 volts line-to-neutral and 208 volts line-to-line (120/208 volts). Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: USA Belvoir Research, Development, and Engineering Center, ATTN: STRBE-TSE, Fort Belvoir, VA 22060-5606 by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.

This document clarifies the limits, test methods and general procedures to the used for measurement of EMI on Mobile Electric Power Generating Sources (MEPGS). Such clarification is necessary as a result of the recent change to MIL-STD-461. Clarification as to the use of MIL-STD-462 is also included. This document is intended to be used as a clarifying supplement to MIL-STD-461 and MIL-STD-462 and does not replace MIL-STD-461 or MIL-STD-462.