Hello. Sign In
Standards Store
MIL-M-38510/423 Revision A, August 9, 1983
Complete Document
Active, Most Current
MICROCIRCUITS, DIGITAL, SCHOTTKY TTL, SYSTEM CONTROLLER AND BUS DRIVER, MONOLITHIC SILICON
Includes all amendments and changes through Validation Notice 4, December 22, 2010
Additional Comments: INACTIVE FOR NEW DESIGN
PDF :
$42.00 USD
In Stock
Print  :
$46.00 USD
In Stock
Print + PDF :
$61.60 USD
You save 30%
In Stock
This specification covers the detail requirements for monolithic silicon, Schottky TTL system controller/bus driver microcircuits. One product assurance class and a choice of case outline and lead finishes are provided for each type and are reflected in the complete part number.

The complete part number shall be as specified in MIL-M-38510. With the exception that the "JAN" or "J" certification mark shall not be used.

Device type shall be as shown in the following:
       Device type                                       Circuit

           01                                   System controller/bus driver




Device class shall be the product assurance level as defined in MIL-M-38510.

The case outline shall be designated as follows:
         Letter                               Case outline, MIL-M-38510, appendix C

           Z                See figure I (28-lead, 5/8" × 1-½", dual-in-line pack)




     DC output current, into outputs - - - -   50 mA
     Supply voltage range (VCC)- - - - - - -   −0.5 to 7.0 Vdc
     Input voltage range - - - - - - - - - -   −1.0 to 7.0 Vdc
     Storage temperature range - - - - - - -   −65° to 150°C
     Maximum power dissipation, PD 1/  - - -
       Device type 01- - - - - - - - - - - -   1.2 Wdc
     Lead temperature (soldering),
       10 seconds- - - - - - - - - - - - - -   300°C
     Thermal resistance, junction to case- -   θJC = 30°C/W for dual-in-line pack
     Junction temperature  - - - - - - - - -   TJ = 175°C




     Supply voltage (VCC)- - - - - - - - -   4.5 Vdc, minimum to 5.6 Vdc,
                                               maximum
     Minimum high level input voltage- - - -   2.0 Vdc
     Maximum low level input voltage - - - -   0.8 Vdc




Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Rome Air Development Center, RBE-2, Griffiss AFB, NY 13441, by using the self addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.
     Setup time,
       Processor bus to [S bar][T bar][S bar][T bar][B bar]- - - - - - - -   12 ns minimum
       System bus to HLDA- - - - - - - - - -   10 ns minimum
     Hold time,
       Processor bus to [S bar][T bar][S bar][T bar][B bar]- - - - - - - -   5 ns minimum
       System bus to HLDA- - - - - - - - - -   20 ns minimum
     Pulse width,
       [S bar][T bar][S bar][T bar][B bar] - - - - - - - - - - - - - - - -   25 ns minimum
     Case operating temperature range (TC) -   −55°to +125°C