Hello. Sign In
Standards Store
MIL-M-38510/43 Revision B, February 28, 1984
Complete Document
Not Active, See comments below
MICROCIRCUITS, DIGITAL, TTL, LOW POWER, PRIORITY ENCORDERS, MONOLITHIC SILICON
Includes all amendments and changes through Validation Notice 1, July 31, 1989
Additional Comments: INAC FOR NEW DESIGN AFTER 02-28-84
PDF :
$32.00 USD
In Stock
Print  :
$35.00 USD
In Stock
Print + PDF :
$46.90 USD
You save 30%
In Stock
This specification covers the detail requirements for monolithic silicon TTL, low power, priority encoders. One product assurance class and a choice of case outlines and lead finishes are provided and are reflected in the complete part number.

The part number shall be in accordance with MIL-M-38510, with the exception that the "JAN" or "J" certification shall not be used.

The device type shall be as follows:
                Device type                            Circuit
                    01                            8-input priority encoder




The device class shall be the product assurance level as defined in MIL-M-38510.

The case outline shall be designated as follows:
           Letter                     Case outlines, (see MIL-M-38510, appendix C)
              E                       D-2 (16-lead, ¼" × ⅞"), dual-in-line package
              F                       F-5 (16-lead, ¼" × ⅜"), flat package




      Storage temperature - - - - - - - - - - - -    −65°C to +150°C
      Temperature (ambient) under bias- - - - - -    −55°C to +125°C
      VCC pin potential to ground pin - - - - - -    −0.5 V to +7.0 V
      *Input voltage (dc) - - - - - - - - - - - -     −0.5 V to +5.5 V
      *Input current (dc) - - - - - - - - - - - -     −30 mA to +5.0 mA
      Voltage applied to outputs (output high)- -    −0.5 V to +VCC value
      Output current (dc) (output low)- - - - - -    +30 mA
      Thermal resistance, junction-to-case (θJC)
        Case F- - - - - - - - - - - - - - - - - -    0.09°C/mW for flat package
        Case E- - - - - - - - - - - - - - - - - -    0.08°C/mW for dual-in-line package




Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Rome Air Development Center (RBE-2), Griffiss AFB, NY 13441, by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.

        Supply voltage - - - - - - - - - - - - - - - -   4.5 V minimum to 5.5 V maximum
        Minimum high level input voltage - - - - - - -   2.0 V
        Maximum low level input voltage- - - - - - - -   0.7 V
        Case operating temperature range - - - - - - -   −55°C to +125°C