Hello. Sign In
Standards Store
MIL-P-85585 1982 Edition, December 6, 1982
Complete Document
Not Active, See comments below
PROBES, EDDY CURRENT, UNSHIELDED, SINGLE COIL
Includes all amendments and changes through Interim Notice 1, August 13, 1997
Additional Comments: INACTIVE FOR NEW DESIGN AFTER 08/13/97
PDF :
$30.00 USD
In Stock
Print  :
$33.00 USD
In Stock
Print + PDF :
$44.10 USD
You save 30%
In Stock
This specification covers unshielded, single coil, absolute eddy current probes used with an eddy current flaw detector (see 6.1).

The probes covered by this specification shall be of the following types, classes and styles, as specified (see 6.2.1):

      Type I    -     Straight surface probes
      Type II   -     Angled surface probes
      Type III  -     Hole probes




      Class 1   -     Probe with integral microdot female connector.
      Class 2   -     Probe with integral microdot female connector and collar.
      Class 3   -     Probe with 6 ft RG 174U cable and two conductor Amphenol
                      (or equivalent) male connector.
      Class 4   -     Probe with 6 ft RG 174U cable and two conductor Amphenol
                      (or equivalent) male connector and collar.
      Class 5   -     Probe with 6 ft RG 174U cable and BNC male connector.
      Class 6   -     Probe with 6 ft RG 174U cable and BNC male connector
                      and collar.




      Style A   -     For 3/16 inch to ¼ inch holes
      Style B   -     For ¼ inch to 5/16 inch holes
      Style C   -     For 5/16 inch to ⅜ inch holes
      Style D   -     For ⅜ inch to 7/16 inch holes


Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Engineering Specifications and Standards Department (Code 93), Naval Air Engineering Center, Lakehurst, NJ 08733, by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.
      Style E   -     For 7/16 inch to ½ inch holes
      Style F   -     For ½ inch to 9/16 inch holes
      Style G   -     For 9/16 inch to ⅝ inch holes
      Style H   -     For ⅝ inch to 11/16 inch holes
      Style I   -     For 11/16 inch to ¾ inch holes
      Style J   -     For ¾ inch to 13/16 inch holes
      Style K   -     For 13/16 inch to ⅞ inch holes
      Style L   -     For ⅞ inch to 15/16 inch holes
      Style M   -     For 15/16 inch to 1 inch holes
      Style N   -     For 1 inch to 1-1/16 inch holes