Hello. Sign In
Standards Store
MIL-STD-1386/41 1974 Edition, June 7, 1974
Complete Document
Active, Most Current
LOADING OF HAZARDOUS MATERIALS AND ASSOCIATED ITEMS IN MILVAN CONTAINERS ROCKET MOTOR, MK 16 AND MODS AND MK 71 MOD 0 AND 1 (ZUNI) IN CONTAINER MK 38 MOD 0 FLEET ISSUE UNIT LOAD
Includes all amendments and changes through Interim Notice 2, April 8, 2014
Additional Comments: INACTIVE FOR NEW DESIGN
PDF :
$28.00 USD
In Stock
Print  :
$31.00 USD
In Stock
Print + PDF :
$41.30 USD
You save 30%
In Stock
GENERAL NOTES

1. THIS DOCUMENT GIVES DETAILED INSTRUCTIONS FOR LOADING THE MILVAN CONTAINER WITH FLEET ISSUE UNIT LOADS OF ROCKET MOTORS, MK 16 & MODS AND MK 71 MOD 0 & 1. MOTORS SHALL BE PALLETIZED IN ACCORDANCE WITH WR-54 28 OR WR-54 257.

2. THE MILVAN SHALL BE EQUIPPED WITH A MECHANICAL LOAD-BRACING SYSTEM THAT MEETS THE REQUIREMENTS OF BUREAU OF EXPLOSIVES PAMPHLET 6C.

3. IN ADDITION TO THE BELT RAILS REQUIRED BY PAMPHLET 6C, THE MILVAN CONTAINER HAS BELT RAILS AT THE 72 AND 83 INCH HEIGHTS FROM THE CONTAINER FLOOR.

4. CONTAINERS ARE EQUIPPED WITH 25 CROSSMEMBERS. UNUSED CROSSMEMBERS MUST REMAIN WITH CONTAINER AND SHALL BE FASTENED INTO BELT RAILS FOR SHIPMENT.

5. WHEN THE LONGITUDINAL SLACK BETWEEN A CROSSMEMBER AND THE UNIT LOAD IS GREATER THAN ONE INCH, USE FILL MATERIAL TO SHIM BETWEEN CROSSMEMBER AND UNIT LOAD AS SHOWN IN DETAIL D.

6. UNIT LOADS ARE LOADED IN A STAGGERED PATTERN WITH THE 1ST AND 3RD DAYS AGAINST LEFT WALL OF MILVAN AND THE 2ND AND 4TH DAYS AGAINST RIGHT WALL OF MILVAN.

7. LENGTH OF STRUIT, PIECE 2, SHALL BE SUFFICIENT TO CAUSE SWAY BRACE ASSEMBLY, DETAIL C, TO BEAR AGAINST UNIT LOAD AND CONTAINER SIDEWALL. TWIST TIE ASSEMBLY TO CROSSMEMBERS WITH 16 GAUSE TIE WIRE, FOUR PLACES.

8. APPLICABLE MATERIAL SPECIFICATIONS:

DUNNAGE LUMBER – FED.SPEC. MM-L-751

NAILS – FED.SPEC. FF-N-105, TYPE II, STYLE 10, COMMON BRIGHT

9. AFTER BLOCKING AND BRACING HAS BEEN INSPECTED, ATTACH SHIPPING DOCUMENTS INSIDE THE CONTAINER IN AN ACCESSIBLE AREA, CLOSE AND SEAL CONTAINER DOORS AND ATTACH APPLICABLE PLACARDS TO THE OUTSIDE OF THE CONTAINER FOR THE APPROPRIATE MODE OF TRANSPORTATION AS PRESCRIBED IN OP 2165 (VOL.I).