Hello. Sign In
Standards Store




PPI TN-48

2013 Edition, August 1, 2013

Complete Document

Guidelines for Choosing Wall Thickness for HDPE Conduit Based on “Mini-HDD” (Horizontal Directional Drilling)



Detail Summary

Active, Most Current

EN
Additional Comments:
NOT AVAILABLE IN HARDCOPY
Format
Details
Price (USD)
PDF
Single User
$25.00
Add to Cart

Product Details:

  • Revision: 2013 Edition, August 1, 2013
  • Published Date: August 2013
  • Status: Active, Most Current
  • Document Language: English
  • Published By: Plastics Pipe Institute (PPI)
  • Page Count: 5
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

Foreword

This technical note was developed and published with the technical help and financial support of the members of the Plastics Pipe Institute. The members have shown their interest in quality products by assisting independent standard-making and user organizations in the development of standards, and also by developing reports on an industry-wide basis to help engineers, code officials, specifying groups, and users.

This technical note has been prepared to provide those responsible for the maintenance of existing HDPE pipelines with suggested general guidelines for the repair of those lines that have been subjected to third party or other unforeseen damage. These guidelines constitute a set of basic operations that have been demonstrated by test and experience to produce satisfactory repairs with commercially available materials. Each specific procedure must be acceptable to, and qualified by, the operator having legal responsibility for the performance of the piping system. This document was not intended to provide system design information. Go to the PPI website at www.plasticpipe.org for different system design documents.

The Plastics Pipe Institute, Inc. has prepared this technical note as a service to the industry. The information in this report is offered in good faith and believed to be accurate at the time of its preparation, but is offered "as is" without any express or implied warranty, including WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Additional information may be needed in some areas, especially with regard to unusual or special applications. Consult the manufacturer or material supplier for more detailed information. A list of member manufacturers is available from PPI. PPI does not endorse the proprietary products or processes of any manufacturer, and assumes no responsibility for compliance with applicable laws and regulations.