Hello. Sign In
Standards Store

PREN 12607-2

2013 Edition, January 2013

Complete Document

BITUMEN AND BITUMINOUS BINDERS - DETERMINATION OF THE RESISTANCE TO HARDENING UNDER INFLUENCE OF HEAT AND AIR - PART 2: TFOT METHOD



View Abstract
Product Details
Document History

Detail Summary

Not Active, See comments below

Additional Comments:
W/D NO S/S
Format
Details
Price (USD)
Print
In Stock
Call for Quote
Add to Cart

Product Details:

  • Revision: 2013 Edition, January 2013
  • Published Date: January 2013
  • Status: Not Active, See comments below
  • Document Language:
  • Published By: British Standards Institution (BSI)
  • Page Count: 13
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This part of EN 12607 describes a method for measuring the combined effects of heat and air on a film of bitumen or bituminous binder, simulating the hardening which most bituminous binders undergo during mixing in an asphalt mixing plant. The method is suitable for other bituminous binders than paving grade bitumen, but the reference temperature might give excessive hardening that do not resemble real conditions during mixing at the plant. The method may not represent the hardening that occurs during mixing of warm mix binders.

Additionally, this part of EN 12607 specifies a method for the determination of the change in mass of oxidised bitumens and hard industrial bitumens after heating. The method is used to detect volatile components, and in EN 13304 and EN 13305, it will be reported as loss in mass.

The method is referred to as TFOT, i.e. Thin Film Oven Test.

WARNING — Use of this European Standard can involve hazardous materials, operations and equipment. This European Standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this European Standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

If there is a likelihood of volatile components being present in a binder, this procedure should not be used. It should not be used for cutback bitumen or bituminous emulsions before these products have been stabilised, e.g. in accordance with EN 13074-2.