1969 Edition, July 15, 1969
Groove Design - Metal Face Seal
Includes all amendments and changes through Reaffirmation Notice , October 2013
Active, Most Current
Need it fast? Ask for rush delivery.
Most backordered items can be rushed in from the publisher in as little as 24 hours. Some rush fees may apply.
Contact your nearest IHS Markit Office to request rush delivery of any backordered item.
Description / Abstract:
Groove designs presented herein are applicable for use with machined or formed metal seals which are similar in configuration to those shown in figure 3, which operate under internal pressure or in vacuum service and which have been specifically qualified or recommended by the purchaser or the manufacturer for use with this AIR. They are also applicable for use with metal o-rings (e.g., MS9142, MS9202, thru MS9205) where interchangebility with machined or formed metal seals is desired. For metal o-rings groove designs where interchangebility is not a requirement refer to ARP 674.