SAE AMS3656 Revision H, August 1, 2011
Polytetrafluoroethylene (PTFE) Extrusions Normal Strength, As Sintered
Includes all amendments and changes through Stabilization Notice (No longer revised / updated) , August 2011
Published By:SAE International (SAE)
This specification covers a virgin, unfilled polytetrafluoroethylene (PTFE) in the form of extruded and sintered rods, tubes, and profiles.
These products have been used typically for parts such as insulators and bushings requiring chemical inertness up to 500 °F (260 °C), but usage is not limited to such applications. For applications such as bearings, seals, and back-up rings that do not require dielectric properties and radiographic inspection it is recommended to use AMS3678/1 Grade B.
Safety - Hazardous Materials
While the materials, methods, applications, and processes described or referenced in this specification may involve the use of hazardous materials, this specification does not address the hazards which may be involved in such use. It is the sole responsibility of the user to ensure familiarity with the safe and proper use of any hazardous materials and to take necessary precautionary measures to ensure the health and safety of all personnel involved.
Types 1 through 4, which were defined in previous revisions of this specification, have been combined. For documentation which specifies Type 1 through Type 4 of this specification, all of the requirements of this specification now apply.