Hello. Sign In
Standards Store

SAE J1304

2011 Edition, October 1, 2011

Complete Document

Cutting Edge - Cross Sections Loader Straight with Bolt Holes

Includes all amendments and changes through Stabilization Notice (No longer revised / updated) , October 2011

View Abstract
Product Details
Document History

Detail Summary

Active, Most Current

Price (USD)
Single User
In Stock
Add to Cart

People Also Bought These:

ISO 15077
SAE J2064
SAE J343

Product Details:

  • Revision: 2011 Edition, October 1, 2011
  • Published Date: October 2011
  • Status: Active, Most Current
  • Document Language: English
  • Published By: SAE International (SAE)
  • Page Count: 3
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

For cutting edges used on buckets for loaders defined in SAE J1057a. The dimensions are applicable to rolled and machined sections only. Cutting edge cross section thickness is limited to a maximum of 35 mm. Bolt-on tooth adapters are rarely used on loader buckets with cutting edge thicknesses in excess of 35 mm. This recommended practice applies only to straight cutting edges defined as those whose leading edge and rear edge are parallel and thus are of constant cross section. Overall cross sections to which bolt holes were added as indicated by this recommended practice were selected from those indicated per "Cutting Edge—Cross Sections Loader Straight," SAE J1303 FEB85. Selection was based on minimum section width requirements to accommodate bolt-on tooth adapters.

NOTE—For some heavy-duty applications, cross sections with larger blunts, greater bevel angles, and larger bolt holes may be required.

Purpose—To specify dimensions for straight cutting edge cross sections with bolt holes for mounting bolt-on tooth adapters on loader buckets described by SAE J731d. It is the intent of this recommended practice to describe the cross sections viable for bolt-on tooth mounting and identify the bolt hole size and location relative to the cutting edge cross section. Thus, a foundation for future standardization of bolt-on tooth adapters is established by the recommended practice.

Rationale—This document has been reaffirmed to comply with the SAE 5-Year Review policy.
AIA/NAS Aerospace Standards