Hello. Sign In
Standards Store
SAE J1998 2008 Edition, June 1, 2008
Complete Document
Not Active, See comments below
Internal Combustion Engines-Piston Rings- Rectangular Rings With Narrow Ring Width
Includes all amendments and changes through Cancellation Notice , June 2008
Additional Comments: CNCL NO S/S
Page Count:18
$98.00 USD
In Stock
Print  :
$98.00 USD
In Stock
AIA/NAS Aerospace Standards
Differences, where they exist, are shown in Appendix A.

This SAE Standard specifies the essential dimensional features of R, B, and M rectangular piston ring types with narrow ring width.

Dimensional Tables 8 and 9 allow for the use of cast iron (Table 8) or steel (Table 9). Since the modulus of elasticity of steel rings is higher than that of cast iron rings, the fluctuation in the surface pressure will become greater if the free gap is set as the reference for force. Therefore, forces are set using the surface pressure as the reference, in order to minimize the effect of the fluctuation.

The requirements of this document apply to rectangular rings for reciprocating internal combustion engines up to and including 90 mm diameter for cast iron rings and up to and including 100 mm diameter for steel. They may also be used for piston rings of compressors working under similar conditions.

Rationale—SAE J1998 is being discontinued because the content of this standard is also contained in ISO 6622-2. Therefore, to eliminate duplication and confusion in coordinating the standards between ISO and SAE, this document will be discontinued. The SAE Piston and Ring Standards Committee will now continue to support ISO in updating the standards as appropriate.