Hello. Sign In
Standards Store




ASTM A381

1996 Edition, September 10, 1996

Complete Document

Standard Specification for Metal-Arc-Welded Steel Pipe for Use with High-Pressure Transmission Systems



Detail Summary

Superseded By: ASTM A381/A381M

EN
Format
Details
Price (USD)
PDF
Single User
$67.00
Print
In Stock
$67.00
PDF + Print
In Stock
$113.90 You save 15%
Add to Cart

Product Details:

  • Revision: 1996 Edition, September 10, 1996
  • Published Date: September 10, 1996
  • Status: Superseded By:
  • Superseded By: ASTM A381/A381M
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 5
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:



1. Scope

1.1 This specification covers straight seam, double-submerged-arc-welded steel pipe (Note 1) suitable for high-pressure service, 16 in. (406 mm) and larger in outside diameter, with wall thicknesses from 5/16 to 1½ in. (7.9 to 38 mm). The pipe is intended for fabrication of fittings and accessories for compressor or pump-station piping. Pipe ordered to this specification shall be suitable for bending, flanging (vastoning), corrugating, and similar operations.

NOTE 1--A comprehensive listing of standardized pipe dimensions is contained in ANSI B36.10.

NOTE 2--The term "double welded" is commonly used in the gas and oil transmission industry, for which this pipe is primarily intended, to indicate welding with at least two weld passes, of which one is on the outside of the pipe and one on the inside.

For some sizes of the pipe covered by this specification, it becomes expedient to use manual welding, in which case the provisions of Note 3 shall be followed.

1.2 Nine classes of pipe, based on minimum yield point requirements, are covered as indicated in Table 1.

1.3 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.

1.4 The following hazard caveat applies to the test methods portion, Sections 9 and 10, only. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.