Hello. Sign In
Standards Store




ASTM D2923

2006 Edition, November 15, 2006

Complete Document

Standard Test Method for Rigidity of Polyolefin Film and Sheeting



Detail Summary

Not Active, See comments below

EN
Format
Details
Price (USD)
PDF
Single User
$58.00
Print
In Stock
$58.00
PDF + Print
In Stock
$98.60 You save 15%
Add to Cart

Product Details:

  • Revision: 2006 Edition, November 15, 2006
  • Published Date: November 15, 2006
  • Status: Not Active, See comments below
  • Document Language: English
  • Published By: ASTM International (ASTM)
  • Page Count: 4
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This test method describes two procedures for measuring the rigidity of polyolefin film and sheeting.

Procedure A prescribes a procedure using high-voltage static eliminators and the use of TFE-fluorocarbon2-coated plates to overcome the spurious effects of static electricity and friction.

Procedure B prescribes the use of a fine powder on uncoated plates to achieve a similar effect.

NOTE 1—Although the two procedures are designed to achieve similar effect, they may not achieve the same results.

The values stated in SI units are to be regarded as standard. The values given in brackets are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

NOTE 2—There is no known ISO equivalent to this standard.

*A Summary of Changes section appears at the end of this standard.


2 This test method is based on the use of Teflon, a registered trademark of E. I. duPont de Nemours & Co.