Hello. Sign In
Standards Store




GMW11 (J)

2004 Edition, April 2004

Complete Document

Electrogalvanized Coatings for Sheet Steel

Includes all amendments and changes through Change/Amendment , April 2004


View Abstract
Product Details
Document History

Detail Summary

Superseded By: GMW11

EN
JA
Additional Comments:
ENGLISH/JAPANESE * INAC S/S BY GMW11
Format
Details
Price (USD)
PDF
Single User
$66.00
Print
In Stock
$66.00
PDF + Print
In Stock
$105.60 You save 20%
Add to Cart

Product Details:

  • Revision: 2004 Edition, April 2004
  • Published Date: April 2004
  • Status: Superseded By:
  • Superseded By: GMW11
  • Document Language: English, Japanese
  • Published By: General Motors Worldwide (GMW)
  • Page Count: 16
  • ANSI Approved: No
  • DoD Adopted: No

Description / Abstract:

This standard covers the requirements for both one and two side pure zinc and zinc nickel alloy electrogalvanized coatings. These coatings are applied to a sheet steel substrate utilizing an electroplating process. The substrate may be either cold or hot rolled low carbon, rephosphorized, solid solution strengthened, bake-hardenable, high strength low alloy or dual phase steel. Additional requirements or agreements shall be specified by the local business units (e.g., NAO, Opel ITDC, GM do Brazil, Holden Ltd., etc.)

Material Description. The type of coating and its mass and finish are specified by suffixes added to the basic specification number. The first two letters EG will designate an electrogalvanized coating. The coating mass for each side is designated by a minimum value in g/m². Only coating masses of 47 g/m², 60 g/m² or 70 g/m² for pure zinc, and 32 g/m² for zinc-nickel alloy should be used unless materials engineering is consulted. Other coating masses shall follow the same designation method. For one side coated coils, or sheets/blanks the uncoated side should be free of coating. A residue of 40 mg/m² max. is permissible. The letter G designates a pure zinc coating. The letter N designates a zinc-nickel alloy coating. The first set of digits along with the letter designation specifies the coating parameters of the unexposed side. The remaining designation specifies E (exposed), or U (unexposed) to depict surface finish.