Hello. Sign In
Standards Store
NFPA T3.5.1 Revision R2, February 14, 2002
Complete Document
Active, Most Current
Hydraulic Fluid Power - Valves - Mounting Surfaces
Includes all amendments and changes through Reaffirmation Notice , 2010
Additional Comments: THIRD EDITION
Page Count:83
$135.00 USD
In Stock
Print :
$149.00 USD
In Stock
IHS Standards Expert
IHS Knowledge Collections
This standard includes mounting surfaces for the following:

— non-return (check) valves;

— compensated fiow control va lves ;

— directional control valves;

— pilot operated non-return (check) valves;

— pressure control valves;

— pressure relief valves;

— sequence valves;

— throttle valves; and

— unloading valves.

This standard includes the following dimensional criteria:

— minimum surface width and length dimensions;

— sizes and locations of ports;

— sizes and locations of tapped holes for mounting fasteners;and

— sizes and locations of dowel or rest pins where required.

This standard provides the following general criteria:

— surface roughness and fiatness;

— indication of appropriate radii;and

— indication of tolerances where pertinent.

This standard only applies to the dimensional criteria of products manufactured in conformance with this standard. It does not apply to their functional characteristics. The maximum working pressure for subplates and manifold blocks with this mounting surface shall be supplied by the manufacturer.