Hello. Sign In
Standards Store
ASTM F837 Revision 02A, July 10, 2002
Complete Document
Standard Specification for Stainless Steel Socket Head Cap Screws
Includes all amendments and changes through Editorial Change 1, December 2004
Page Count:8
$61.00 USD
In Stock
Print :
$61.00 USD
In Stock
IHS Standards Expert
IHS Knowledge Collections
This specification covers the chemical and mechanical requirements for stainless steel inch socket head cap screw (SHCS) with nominal thread 0.060 through 1.500 in. and intended for use in applications requiring general corrosion resistance.

Two groups of stainless steel alloys are covered, austenitic Group 1 and martensitic Group 5.

Four property conditions are covered: austenitic Alloy Group 1 in an annealed condition (AF) at 85 ksi maximum, in two cold worked conditions (CW) at 80 ksi minimum, (CW1) at 102 ksi minimum, and martensitic Alloy Group 5 in a heat treated condition (HT) at 160 ksi minimum.

The following precautionary caveat pertains only to the test method portion, Section 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.