Hello. Sign In
Standards Store
ISO 898-5 2nd Edition, August 1, 1998
Complete Document
Mechanical Properties of Fasteners Made of Carbon Steel and Alloy Steel - Part 5: Set Screws and Similar Threaded Fasteners Not under Tensile Stresses
Additional Comments: ENGLISH
$65.00 USD
In Stock
Print :
$82.00 USD
In Stock
IHS Standards Expert
IHS Knowledge Collections
This part of ISO 898 specifies the mechanical properties of set screws and similar threaded fasteners not under tensile stresses with nominal thread diameters from 1,6 mm up to and including 24 mm, which are made of carbon steel or alloy steel.

The mechanical and physical properties apply when tested at an ambient temperature of 10 °C to 35 °C and will vary at higher or lower temperatures.

This part of ISO 898 does not apply to set screws requiring special properties such as

— specified tensile stresses (see ISO 898-1);

— weldability;

— corrosion resistance;

— ability to withstand temperatures above + 300 °C or below – 50 °C.

NOTE — Set screws made from free-cutting steel should not be used above + 250 °C.