BS ISO 1101 2005 Edition, January 25, 2005
Geometrical Product Specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out
Includes all amendments and changes through Change/Amendment , January 25, 2005
Additional Comments: RENUMBERED AS BS EN ISO 1101
Published By:British Standards Institution (BSI)
This International Standard contains basic information and gives requirements for the geometrical tolerancing of workpieces.
It represents the initial basis and defines the fundamentals for geometrical tolerancing.
NOTE Other International Standards referenced in Clause 2 and in Table 2 provide more detailed information on geometrical tolerancing.