Hello. Sign In
Standards Store
ASTM A82/A82M Revision 05A, October 1, 2005
Complete Document
Standard Specification for Steel Wire, Plain, for Concrete Reinforcement
Page Count:5
$54.00 USD
In Stock
Print :
$54.00 USD
In Stock
IHS Standards Expert
IHS Knowledge Collections
(Footnote *)

This specification covers cold-drawn steel wire, as-drawn or galvanized, to be used as such, or in fabricated form, for the reinforcement of concrete, in sizes not less than 2.03 mm [0.080 in.] nominal diameter.

Supplement S1 describes high-strength wire, which shall be furnished when specifically ordered. It shall be permissible to furnish high-strength wire in place of regular wire if mutually agreed to by the purchaser and the manufacturer.

The values stated in either SI units or inch-pound units are to be regarded as standard. Within the text the inch-pound units are shown in brackets (except in Table 6). The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values may result in nonconformance with the specification.

Footnote * - A Summary of Changes section appears at the end of this standard.