Hello. Sign In   |    Help & Support   |    Contact Us   |   
Standards Store
SEARCH:
and/or  
ASTM A496/A496M (Complete Document)
Revision / Edition: 07 Chg: Date: September 1, 2007
STANDARD SPECIFICATION FOR STEEL WIRE, DEFORMED, FOR CONCRETE REINFORCEMENT
Additional Comments: W/D S/S BY A1064/A1064M
Page Count:6
PDF :
$60.00 USD
In Stock
Print :
$60.00 USD
In Stock
ASTM BOS
IHS Standards Expert
This specification covers deformed steel wire which has been cold-worked by drawing, rolling, or both drawing and rolling, to be used as produced, or in fabricated form, for the reinforcement of concrete in sizes having nominal crosssectional areas not less than 6.45 mm2[0.01 in.2].

Supplement S1 describes high-strength wire, which shall be furnished when specifically ordered. It shall be permissible to furnish high-strength wire in place of regular wire if mutually agreed to by the purchaser and manufacturer.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. (The inch-pound units are shown in brackets except in Table 1).

*A Summary of Changes section appears at the end of this standard.

Prices subject to change without notice.
Help & Support
Home
Help & Support
Office Locations
Abbreviations Definitions
Products
Browse Publishers & Products
New Releases
Top Sellers
Tools & Services
Research Center
Alerts & Content Tools
Deposit Accounts
Standing Orders
Free Newsletters
Solutions
Individual Standards
Custom Online Collections
Online Corporate Solutions
 
Visit www.ihs.com
About IHS  |   Contact Us  |   Careers  |   Investors  |   Site Map  |   Privacy Policy  |   Terms of Use (c) 2014 IHS.