Hello. Sign In
Standards Store
ASTM D2103 2005 Edition, December 1, 2005
Complete Document
Standard Specification for Polyethylene Film and Sheeting
Page Count:5
$61.00 USD
In Stock
Print :
$61.00 USD
In Stock
IHS Standards Expert
IHS Knowledge Collections
This specification covers the classification of polyethylene film and sheeting up to 0.3 mm [0.012 in.] in thickness, inclusive. The film or sheeting may contain additives for the improvement of the surface properties, pigments, or stabilizers, or combinations thereof.

The values stated in SI units are to be regarded as standard. The values given in brackets are for information only.

The following precautionary caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

This specification allows for the use of recycled polyethylene film or resin as feedstock, in whole or in part, as long as all the requirements as governed by the producer and end user are also met (see Note 1).

 NOTE 1—Guide D 5033 describes terminology and definitions related to recycled plastics.

 NOTE 2—There is no known ISO equivalent to this specification.

*A Summary of Changes section appears at the end of this standard.