Hello. Sign In   |    Help & Support   |    Contact Us   |   
Standards Store
  •  Shopping Cart  (0) 
      Your Shopping Cart is empty.
      If you already have an account, Sign In
      If you are new to IHS, Create New Account
SEARCH:
and/or  
AASHTO M 111M/M 111 (Complete Document)
Revision / Edition: 14    Chg:    Date: 00/00/14   Abbreviations Definitions
Active, Most Current
STANDARD SPECIFICATION FOR ZINC (HOT-DIP GALVANIZED) COATINGS ON IRON AND STEEL PRODUCTS **SAME AS ASTM A123/A123M**
Additional Comments:ONLY AVAILABLE IN ELECTRONIC FORMAT
Published By:American Association of State Highway and Transportation Officials (AASHTO)
Page Count:14
PDF :
$42.00 USD
  In Stock
Product Family
Previous Editions
Referenced Items
There are no items in this referenced list
People Also Bought These
AASHTO M 180
AIAA S-102.1.4
AIAA S-102.1.5
AIAA S-102.2.11
AIAA S-102.2.18
More...
Related Products
There are no related products.
IHS Standards Expert
Description / Abstract Back to Top
This specification covers the requirements for zinc coating (galvanizing) by the hot-dip process on iron and steel products made from rolled, pressed and forged shapes, castings, plates, bars, and strips.

This specification covers both unfabricated products and fabricated products, for example, assembled steel products, structural steel fabrications, large tubes already bent or welded before galvanizing, and wire work fabricated from uncoated steel wire. This specification also covers steel forgings and iron castings incorporated into pieces fabricated before galvanizing or which are too large to be centrifuged (or otherwise handled to remove excess galvanizing bath metal).

Note 1—This specification covers those products previously addressed in M 111-80, ASTM A 123-78, and ASTM A 386-78.

This specification does not apply to wire, pipe, tube, or steel sheet that is galvanized on specialized or continuous lines, or to steel less than 0.76 mm [22 gauge (0.0299 in.)] thick.

The galvanizing of hardware items that are to be centrifuged or otherwise handled to remove excess zinc (such as bolts and similar threaded fasteners; castings; and rolled, pressed, and forged items) shall be in accordance with M 232M/M 232.

Fabricated reinforcing steel bar assemblies are covered by the present specification. The galvanizing of separate reinforcing steel bars shall be in accordance with ASTM A 767/A 767M.

This specification is applicable to orders in either SI units (as M 111M) or inch-pound units (as M 111). SI units and inch-pound units are not necessarily exact equivalents. Within the text of this specification and where appropriate, inch-pound units are shown in brackets. Each system shall be used independently of the other without combining values in any way. In the case of orders in SI units, all testing and inspection shall be done using the metric equivalent of the test or inspection method as appropriate. In the case of orders in SI units, such shall be stated to the galvanizer when the order is placed.
Additional Supplemental Documents

Prices subject to change without notice.
Help & Support
Home
Help & Support
Office Locations
Abbreviations Definitions
Products
Shop by Industry
Browse Publishers & Products
Featured Products
New Releases
Top Sellers
Tools & Services
Research Center
Alerts & Content Tools
Deposit Accounts
Standing Orders
Free Newsletters
Solutions
Individual Standards
Custom Online Collections
Online Corporate Solutions
 
Visit www.ihs.com
About IHS  |   Contact Us  |   Careers  |   Investors  |   Site Map  |   Privacy Policy  |   Terms of Use (c) 2014 IHS.