Hello. Sign In
Standards Store
ASTM C666/C666M 2003 Edition, June 10, 2003
Complete Document
Standard Test Method for Resistance of Concrete to Rapid Freezing and Thawing
Page Count:6
$61.00 USD
In Stock
Print :
$61.00 USD
In Stock
IHS Standards Expert
IHS Knowledge Collections
This test method covers the determination of the resistance of concrete specimens to rapidly repeated cycles of freezing and thawing in the laboratory by two different procedures: Procedure A, Rapid Freezing and Thawing in Water, and Procedure B, Rapid Freezing in Air and Thawing in Water. Both procedures are intended for use in determining the effects of variations in the properties of concrete on the resistance of the concrete to the freezing-and-thawing cycles specified in the particular procedure. Neither procedure is intended to provide a quantitative measure of the length of service that may be expected from a specific type of concrete.

The values stated in either inch-pound units or SI units shall be regarded seperately as standard. The SI units are shown in brackets. The values stated may not be exact equivalents; therefore each system must be used independently of the other. Combining values from the two units may result in nonconformance.

All material in this test method not specifically designated as belonging to Procedure A or Procedure B applies to either procedure.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.