|Description / Abstract
||Back to Top
|These requirements cover shop fabricated, aboveground
atmospheric Protected Tanks intended for storage of stable
flammable, or combustible liquids that have a specific gravity not
greater than 1.0 and that are compatible with the material and
construction of the tank.
These requirements do not cover Fire Resistant Tanks which are
intended for installation and use in accordance with the Automotive
and Marine Service Station Code, NFPA 30A. These tanks are covered
in UL's Outline of Investigation for Fire Resistant Tanks for
Flammable and Combustible Liquids, Subject 2080.
These tank constructions are intended to limit the heat
transferred to the primary tank when the construction is exposed to
a 2-hour hydrocarbon pool fire and are provided with protection
from physical damage. Tanks appropriately identified by product
markings provide additional protection for the primary tank against
projectile impact and vehicle impact.
These tanks shall be provided with integral secondary
containment intended to prevent any leakage from the primary tank
from entering the environment.
Protected Tanks are intended for stationary installation and use
in accordance with the Uniform Fire Code, published by the
International Fire Code Institute; the Flammable and Combustible
Liquids Code, NFPA 30; and the Automotive and Marine Service
Station Code, NFPA 30A.
Tanks covered by these requirements are fabricated, inspected,
and tested for leakage before shipment from the factory as
completely assembled units.
These requirements and tests are not intended to determine a
tank's acceptability for use after fire exposure, vehicle impact,
or projectile impact.
These requirements do not address methods of anchoring which may
be required to prevent uplift from flooding or movement due to wind
or seismic forces.
These requirements do not address either the construction, or
attachment means of ladders, stairs, runways, guardrails,
platforms, or equipment supports.
A product that contains features, characteristics, components,
materials, or systems new or different from those covered by the
requirements in this Standard, and that involves a risk of fire,
electric shock, or injury to persons shall be evaluated using the
appropriate additional component and end-product requirements to
determine that the level of safety as originally anticipated by the
intent of this Standard is maintained. A product whose features,
characteristics, components, materials, or systems conflict with
specific requirements or provisions of this Standard shall not be
judged to comply with this Standard. Where appropriate, revision of
requirements shall be proposed and adopted in conformance with the
methods employed for development, revision, and implementation of
|Additional Supplemental Documents