Hello. Sign In
Standards Store
ASTM A1011/A1011M Revision 05A, December 1, 2005
Complete Document
Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High- Strength Low-Alloy and High-Strength Low-Alloy with Improved Formability
Page Count:8
$61.00 USD
In Stock
Print :
$61.00 USD
In Stock
IHS Standards Expert
IHS Knowledge Collections
This specification covers hot-rolled, carbon, structural, high-strength low-alloy, and high-strength low-alloy with improved formability steel sheet and strip, in coils and cut lengths.

Hot rolled steel sheet and strip is available in the designations as listed in 4.1.

This specification is not applicable to the steel covered by Specification A 635/A 635M.

The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.

*A Summary of Changes section appears at the end of this standard.